Add:9F, Dongguan Building, Jiangnan Ave 4288, Binjiang District, Hangzhou
Note the use of
Test cable assemblies should be checked before using the cable connection and device interface matches, especially the precision of millimeter wave connector.
When you use the test cable assemblies, you must use a torque wrench tighten, but cannot exceed the maximum torque connector provides.
The correct Connector connection method is: the male and female connectors of the same type after the alignment, one hand holding the female head, one hand and rotating the head lock nut, and ensure the conductor not relative rotation, rotation is strictly prohibited female connection. If the structure is non-slip knurled nut finger tight.
Test cable should be used to minimize the number of bends, otherwise it will shorten the service life of the cable. Due to the testing environment is complex, requires bending, bending radius not less than the minimum bending radius of the cable itself.
When you use the test cable assemblies, should ensure the desktop clean and tidy, any shocks, squeezing may damage the electrical properties of the cable.
Without permission is strictly prohibited to install cable protection sleeve, so as not to damage the cable's mechanical structure and shorten its life.
Shall promptly remove the end of the test the test cable, check the connector interface is clean, if damaged, depth is within range, confirmed after use clean compressed air to blow off debris attached to the media surface, covered with protective cap and deposited in the appropriate environment.
Prohibited the use of questionable test cables, so as not to damage the DUT and test systems interface, affecting the accuracy of testing of the DUT.