Home > News > Content

Product Categories

  • CONTACT US

  • Add:9F, Dongguan Building, Jiangnan Ave 4288, Binjiang District, Hangzhou

  • M.B: +86-18969122786

  • TEL: +86-571-86631886

  • FAX: +86-571-89930536

  • Email:sales@cenrf.com

Power Splitter Dirty How To Do It
Jun 22, 2017

Power Splitter dirty how to do it
    If the clothes are dirty, we will of course clean. Machinery and equipment is no exception, but the cleaning process and methods are not the same. Let's take a look at the method of cleaning the liquid coupling.
    ① the disintegration of hydraulic components, process plug and interference with the Department may not be demolished, combined with the surface sealant seal removed.
    ② all cleaning parts should be placed in the container, with a manual pressure suction guns repeatedly rinse the parts of the cavity and oil, when the cleaning to reach the target without any dirt, and then cleaning detergent once.
    And then stir the container to remove 100ml of gasoline, placed in a glass tube, observed in the bright, such as visual observation of any visible foreign matter and suspended impurities, this time can be considered clean.
    ③ who can not be placed in the container of large pieces, must also be connected with the container, with a cup of oil clean.
    ④ After cleaning the parts of the oil and rinse the oil tank with filter paper filter.
    ⑤ filter the filter paper into the weighing bottle, half-cover conditions into the 100 ℃ drying box drying 1 hour, remove the appropriate cover, should be placed in the dryer after cooling 0.5 hours and then the total weight on the balance The
The working fluid of the Power Splitter is the medium that transmits the torque of the coupler, and how much of the power divider has a relatively large effect on the transmission torque of the coupler and the overload protection.
For the same type and specification of the coupler, the amount of liquid filling directly affects the size of the coupler transmission torque. Its basic law is in the provisions of the liquid filling range, the more liquid charge the more the coupling torque is greater. When the transmission torque is constant, the more the liquid charge amount, the higher the efficiency of the power distributor, but the starting torque will increase at this time, the overload factor will increase accordingly. You can use a different amount of liquid, so that the same specifications of the coupler and several different power motor match to apply different work machine requirements.
Power Splitter with the size of the hydraulic coupling has a certain transmission torque range, known as the power band, the power band with the coupling liquid filling range corresponds. Under normal circumstances, the power distributor of the liquid filling range should be the total volume of the coupler 60% to 80%, can not exceed this range, can not be filled. When the liquid coupling liquid filling capacity exceeds 80% of the volume, the coupler in the rotation, due to overload and rapid temperature rise and pressure, resulting in the expansion of the working fluid volume, the coupling of the internal pressure increases, it will destroy Oh Sealed, causing leakage, and even cause the coupling of the shell cracking, resulting in mechanical damage.


CenRF Communications Limited
Add:9F, Dongguan Building, Jiangnan Ave 4288, Binjiang District, Hangzhou
Contact:Alan Huang
Tel: +86-571-86631886
Fax: +86-571-89930536
Mobile: +86-18969122786
E-mail: sales@cenrf.com

Quick Navigation
  • About Us
  • Product
  • Download
  • Service
  • News
  • Contact Us
  • Newsletter
    Enter in your email address to receive deals and coupons.
    +86-571-86631886
    +86-571-86631886 sales@cenrf.com